Cdi5450 Hot Tap Flowmeter For Steel Pipes (6″)

The CDI 5450 is a modified version of the 5400 model that allows installation under pressure. It incorporates two valves through which the probes pass and a muffler that collects chips from the drilling process. It takes an equal amount of installation time as our standard meters and requires no shutdown of the compressed-air system.

Like all of our 5000-series meters, it measures flow by maintaining one probe warmer than the other. It deter-mines the mass flow rate from the amount of heat re-quired. The flow rate, in scfm or equivalent units, is shown on a large, four-digit display; a 4-20 mA output and a pulse output permit remote display, totalizing and data collection. Features: – No system shutdown required- Installs in minutes- Weather resistant and surge protected- Milliamp output- Pulse output convertible to threshold output- User-configurable scaling, filtering and units of measure- Optional wired or wireless output for networking- Housing rotates to suit vertical or horizontal installation

Specifications

– Accuracy: 5 percent of reading plus 1 percent of range for flows from 10 percent to 100 percent of indicated range at air temperatures between 20 and 120 degrees Fahrenheit- Fluids: Compressed air and Nitrogen- Range: 5000 scfm- Operating pressure: 130 psig maximum on Sch. 40 steel- Input power: 250 mA at 24 Vdc- Output resistance: 600 Ohms max.- Materials exposed to measured fluid: Stainless steel, gold, thermal epoxy and Viton (seal)- Display: Four-digit LED display- Response time: One second to 63 percent of change in value at flows above 30 percent of range